Exterior lighting
Active Bending Lights
Active Bending Lights (ABL) are designed to help provide extra illumination in curves and intersections.
Active high beam
Active high beams is a function that uses camera sensors in the upper edge of the windshield to detect the headlights of approaching vehicles or the taillights of the vehicle directly ahead. When either of these is detected, the vehicle's headlights will automatically switch from high beams to low beams.
Using turn signals
The vehicle's turn signals are controlled using the left-side steering wheel lever. The turn signals flash three times or continuously, depending on how far up or down the lever is moved.
Brake lights
The brake lights are automatically illuminated when braking.
Rear fog light
The rear fog light is considerably brighter than the ordinary taillight and should only be used to help other road users see the vehicle when visibility is reduced by conditions such as fog, snow, smoke or dust.
Low beams
When driving with the lighting ring in the position, low beam will be automatically activated in weak daylight or dark conditions, when the ignition is in the II position.
Using high beam
High beam is operated via the left-hand steering wheel lever. High beam is the vehicle's strongest lighting and should be used when driving in dark conditions, provided it does not blind other road users, to improve visibility.
Using home safe lighting
Some of the exterior lights remain on to illuminate the area around the vehicle. This is called home safe lighting.
Emergency brake lights
The emergency brake lights are activated to warn following vehicles of hard braking. This function causes an additional taillight on each side of the vehicle to illuminate.
Parking lights
The parking lights can be used to help other road users see the vehicle if it is stopped or parked. Use the lighting ring on the steering wheel lever to turn on the parking lights.
Welcome Light
Approach lighting is activated when the vehicle is unlocked and can be used to provide light as you walk toward the vehicle.
Hazard warning flashers
Hazard warning flashers warn other road users by all of the vehicle's turn signals being activated at the same time. The function can be used to warn about a traffic hazard.
Daytime running lights
The vehicle has sensors that detect ambient lighting conditions. With the lighting ring in the position, the daytime running lights will always be activated when the ignition is in mode II. In weak daylight or dark conditions, the headlights automatically switch to low beams.