• Manual
  • Video gallery
  • Software updates

Charging in vehicle's center display

The center display can be used to set charging level, unlock the charging cable and set charging power capacity (amperage).

Setting a charging limit

PS2- 2007- iCup charge status
  1. PS-Icon circle 1The battery's current charge level.
  2. PS-Icon circle 2Swipe to set desired charge level. Charging limit – Swipe to set a charge level at which charging should stop. The set limit remains the same until it is changed again in the center display.

 Important

Follow the recommendations for high-voltage battery handling to optimize its lifetime and performance.

Unlocking the charging cable

Tap PS2- 2007- Charging unlock cable CSD on the center display to unlock the charging cable and stop ongoing charging.

Setting amperage

It is possible to set the current when AC1 charging. Tap + to increase the current or - to reduce the current2.

 Note

The current can be restricted by a charging station or charging cable. It cannot be guaranteed that the vehicle is charged with the current specified if it is higher than what the charging station or charging cable allows.
  1. 1 Regards charging via charging station (mode 3) and charging via wall outlet (mode 2).
  2. 2 Set current applies per phase from the AC power source.

Related articles