• Manual
  • Video gallery
  • Software updates

Charging in the vehicle's center display

The center display can be used to set charge level, unlock the charging cable and set charging power capacity (amperage).

Setting a charging limit

PS2- 2007- iCup charge status
  1. PS-Icon circle 1The battery's current level of charge.
  2. PS-Icon circle 2Swipe to set desired charge level. Charging limit – Swipe to set a limit for the state of charge at which charging should stop. The set value will remain the same until it is changed again in the center display.

 Important

Follow the recommendations for high-voltage battery handling to optimize its lifetime and performance.

Schedule charging

When charging using alternating current, it is possible to schedule and set start and stop times for charging. The schedule is then repeated automatically at the same time every day.

PS2-23w46-Scheduled charging overview

Select ChargingSet timer in the center display and then activate the scheduled charging times in Schedule. Drag the control to set the desired charging start and stop times.

Deactivate the scheduled charging using the Schedule charging control.

Unlocking the charging cable

Tap PS2- 2007- Charging unlock cable CSD in the center display to unlock the charging cable and cancel ongoing charging.

Setting amperage

It is possible to set the current intensity1 (amperage) for charging with alternating current. Tap + to increase the amperage or - to reduce the amperage2.

 Note

The current can be restricted by a charging station or charging cable. It cannot be guaranteed that the vehicle is charged with the current specified if it is higher than what the charging station or charging cable allows.
  1. 1 Refers to charging at a charging station (mode 3) and charging using a wall socket (mode 2).
  2. 2 The set amperage applies per phase from the alternating current source.

Related articles