Warning and auto-brake when reversing*
The Rear Auto Brake (RAB)* and Cross Traffic Alert (CTA)* functions are only active if the car rolls backwards or if reverse gear has been selected.
- A warning signal and the parking assistance graphic illuminate to indicate the position of the obstacle.
- If the driver ignores the warning and a collision is unavoidable, the car may be auto-braked, and an explanatory text message is shown for why the car was braked.
If the accelerator pedal is depressed forcefully then the car also reverses after braking automatically.
Warning
- The functions are supplementary driver support intended to facilitate driving and make it safer – they cannot handle all situations in all traffic, weather and road conditions.
- The driver is advised to read all sections in the manual that relate to these functions in order to learn about factors such as limitations, among other things, and what the driver should be aware of before using the functions.
- Driver support functions are not a substitute for the driver's attention and judgement. The driver is always responsible for ensuring the car is driven in a safe manner, at the appropriate speed, with an appropriate distance to other vehicles, and in accordance with current traffic rules and regulations.
Note
Obstacles immediately behind
Rear Auto Brake is intended to help the driver detect stationary obstacles that may be directly behind the car when it is being reversed.
This function is primarily designed to detect stationary obstacles that are higher than the rear bumper – and not moving vehicles, for example.
Brake intervention with Rear Auto Brake is active at speeds below 10 km/h (6 mph).
The auto brake needs to be deactivated before using an automatic car wash, and may also need to be deactivated to avoid unwanted intervention, e.g. when reversing in tall grass.
Obstacles from the side
Cross Traffic Alert is designed to help the driver detect traffic crossing behind the car when it is reversing.
This function is primarily designed to detect larger vehicles in motion. In favourable conditions it may also be able to detect smaller objects, such as cyclists and pedestrians.
Brake intervention with Cross Traffic Alert is active at speeds below 15 km/h (9 mph).
The auto brake needs to be deactivated before using an automatic car wash, and may also need to be deactivated to avoid unwanted intervention, e.g. when reversing in tall grass.
Examples of detection and limitations
The function's sensors cannot detect moving traffic through other parked vehicles or bulky obstacles. Here are some examples of when approaching vehicles cannot therefore be detected until they are very close.
Blind sector
Sector in which the function can detect
However, as your car slowly reverses, the angle it makes with the obstructing vehicle/object changes and the blind sector rapidly decreases.
Reversing with equipment connected to the towbar
RAB and CTA are deactivated automatically when a trailer, bicycle rack or similar is connected to the towbar connector. If the connected equipment has no electrical connection, RAB and CTA must be deactivated manually by pressing a button in the centre display.
