Location of adjuster knobs

There are four adjuster knobs, two for the front shock absorbers and two for the rear. The adjusting knobs are located by each wheel.

For the front wheels, the adjusting knobs are located in the bottom of the shock absorber, close to the wheel. The adjusting knobs for the rear wheels are located above each of the wheels in the wheel housing.

To access the front adjuster knobs, it is sufficient to angle the wheel until the shock absorber becomes visible. To access the rear adjuster knobs, loosen the wheel housing's wing liner and raise the car, use a jack for example, see separate section.

Adjusting the setting for damping, front

To get to adjustment position 0, turn the adjuster knob clockwise as seen from below until it reaches the stop.

 Important

Do not tighten the adjuster knob too hard – the dampers may be damaged by excessive tightening torque.

Turn the adjuster knob anticlockwise to select the desired adjustment position. Adjustment positions are defined with an audible and noticeable click.

Then carry out the same procedure for the other shock absorber.

Adjusting the setting for damping, rear

Raise the car to access the wheel housing.

Unscrew two of the nuts to access under the liner. The liner must not be completely removed.

Reach your hand up under the liner and remove the protective rubber cover that covers the adjuster knob.

To select adjustment position 0, turn the adjuster knob clockwise, seen from below, until it stops. Use this as the starting point to find the required adjustment position.

 Important

Do not tighten the adjuster knob too hard – the dampers may be damaged by excessive tightening torque.

Turn the adjuster knob anticlockwise to select the desired adjustment position. Adjustment positions are defined with an audible and noticeable click.

When the desired position has been set, refit the protective rubber cover. Then carry out the same procedure for the other shock absorber.

Recommended positions