Driving lights mix automatic behaviours and manual controls which allow you to adapt to any situation or visibility conditions.
Important
The driver is always responsible for ensuring that the car is driven while using a lights mode that is suitable for the current driving conditions and local traffic regulations.
Primary lighting
You can choose between several different primary lighting modes in the centre display. Your selection sets a standard lighting behaviour.
The automatic lights mode1 allows your car to automatically detect and calculate which lighting mode is most suitable for the driving and environmental lighting conditions.
You can manually select the passing beam to keep the front lights dipped.
The position lights are points of illumination around the car that make your car more visible to other road users.
The rear fog light warns traffic behind you of your presence in poor light conditions. It is enabled in the centre display.
You can run tests from the centre display to check the lights on a connected trailer.
Articles in this category
Operating the driving lights
Familiarise yourself with operating the lights that are available via the left-hand steering wheel stalk.
High beam
The high beam is important for your driving visibility. There are different states you can use to suit your needs.
Passing beam
The passing beam reduces the risk of dazzling other road users.
Active bending lights
Active bending lights work during turns to actively shift the light towards where you are steering.
Activating the rear fog light
The rear fog light is designed to warn traffic behind you of your presence in bad weather with poor light conditions.
Activating the position lights
The position lights make your car more visible to other road users. You can leave the car locked with the position lights on.
Hazard warning lights
If there is a potential risk to surrounding traffic, you should turn the hazard warning lights on. This helps to alert other road users of the need for greater awareness.