Procedure to temporarily change the automatic high beam sensitivity

You can set an alternative automatic high beam sensitivity in accordance with FMVSS108 requirements.

The vehicle must be stationary to change the sensitivity. Keep the brake pedal pressed down throughout the procedure.

Put the vehicle in drive by selecting Dwith the right-hand steering wheel stalk.

Press the vehicle symbol

in the bottom bar and go to Exterior.

Go to Lights → Exterior lights.

Make sure that the default automatic lights mode1 is selected.

Press the low beam symbol

Activate the high beam flash with a short pull on the left-hand steering wheel stalk.

Select automatic lights mode1 again.

Activate the high beam flash again with a short pull on the left-hand steering wheel stalk.

Press the passing beam symbol

again.

Activate the high beam flash once more with a short pull on the left-hand steering wheel stalk.

Select automatic lights mode1.

The sensitivity returns to the default setting when you start a new drive cycle.

Specifications